CLICK FOR HOME PAGE
It is easy to run control wiring with bars mounted on the bike or keep the
foam on them and there will be less chance you will scratch the finish.
On some bikes the wire loom plastic cover is very thick and loose and
will not feed through bars easy, remove plastic cover and use new
heat shrink tubing to cover wires. This is easy to do and heat
shrink can be purchased at your local electronics or hardware store.

These lead wires are both going to the right side for the electronic throttle and button wiring.
TBW and button wires should be run through symotainiously.

*Do not pull too hard on the wires for the E-Throttle*

Right side has new shrink tube on button wires.
Dry Silicone spray makes inside bar slippery for running wires.

PICTURES OF FINNISHED PRODUCT: WO515B ON 2011 ROADGLIDE

Info provided by HD Bike Parts